Quick Start Guide

™
For Your Information...
The Next-Generation Wireless Lighting line of products consists of:
• Adaptive Phase Dimmer, 120V (C4-APD120)
• Adaptive Phase Dimmer, 240V (C4-APD240)
• Adaptive Phase Dimmer, 277V (C4-APD277)
• Forward Phase Dimmer, 120V (C4-FPD120)
• Keypad Dimmer, 120V (C4-KD120)
• Keypad Dimmer, 240V (C4-KD240)
• Keypad Dimmer, 277V (C4-KD277)
• Configurable Keypad, 120V - 277V (C4-KC120277)
• Configurable Keypad, 240V (C4-KC240)
• Switch, 120V - 277V (C4-SW120277)
• Switch, 240V (C4-SW240)
• Auxiliary Keypad, 120V - 277V (C4-KA)
• 0-10V Dimmer, 120V - 277V (C4-TV120277)
• 0-10V Dimmer, 240V (C4-TV240)
• Fan Speed Controller, 120V (C4-4SF120)
• Faceplate (C4-FP1-xx, C4-FP2-xx, C4-FP3-xx, and C4-FP4-xx)
Things to Consider Before You Install These Devices
1 The use of HC-250 or HC-800 Controllers as ZAPs is highly recommended. The lighting scene ramping and load
group features are not supported with legacy controllers.
2 In new construction, meet with the electrician prior to rough-in wiring to ensure that all devices are wired with
a neutral in the wallbox. Also ensure that any ceiling fans have separate control wires for the lights and fan, and
that a double-gang space has been provided for the control of the light and fan.
3 When using energy-ecient loads, such as LEDs, test the actual loads in the planned configuration ahead of
time to ensure compatibility.
4 Before you install the keypads, talk to your customer about what configuration they want for their buttons.
5 Discuss engraving requirements with your customer. We recommend engraving all keypad buttons as well as all
dimmer/switch buttons in multi-gang boxes. Print out the Engraving Report from Composer Pro, and review the
report with your customer prior to ordering engraved buttons.
Things to Consider When Adding the Next-Generation Wireless Lighting Products to the Composer Pro Project
1 Choose the default device LED colors in the project settings prior to adding any devices.
2 Leave the backlight color set to Black until the engraved buttons are added to the devices. Turning the backlight
on without engraved buttons will cause light bleed-through into the status LEDs and unnecessary energy use.
Next-Generation Wireless Lighting Quick Start Guide