Setup guide

Followthesestepstocongureawirelesssetup:
a Ifyoudon’tseethenetworkyouwant,select
Other.
b AtNetworkName,selecttoaddtheSSID
ornameofthewirelessnetworkwhenthe
keyboardappears.
c AtSecurity,selectNone,WEP,orWPA.
d AtPassword,typethepasswordgivento
youbythepersonwhosetupthecustomer’s
wirelessnetwork(Control4Dealer).
e SelectConnect.NoticethattheIPsettings
change.
4 TheIPaddressissettoDHCPbydefault.Ifyou
needtosetastaticIPaddress,completethe
followingsteps;otherwise,youarenishedwith
thesesteps.
a OntheNetworkpage,tapStatic (see Figure
8).
Figure8.StaticIPAddress
b Selecteachboxoneatatime,andtypethe
address:IPAddress,SubnetMask,Default
Gateway,PreferredDNS,andAlternateDNS.
c Whenthekeyboardappears,typethe
address,andthentapDone.
d TapOKtoreturntotheNetworkpage.
YoucannowconnecttoaControl4Directorrunning
onaControl4deviceonthenetwork.
Connect to Director from the Touch
Screen
NOTES:(1)TheTouchScreen’scontrolsare
auto-populatedbyaprojectontheController
towhichitconnects.Ifthesubsystembuttons
arenotlit,andnodefaultroomdisplayson
theTouchScreen,youarenotconnectedto
aController.(2)Ensurethatthedevicesare
addedtoComposerandidentiedinthe
project.See“CongureinComposer”for
details.
1 OntheHomepage,tapMore>Settings.
2 TapDirector.
3 IftheDirectorpagedoesnotdisplay,theDirector
viewhasprobablybeendisabled;youmust
provideapasswordtoenableit.
• Ifyouneedthepassword,contactyourControl4
DealerifyouaretheInstaller.
• Ifyouhavethepassword,tapConfig>Disable
View,enterthepassword,andthentapDirector
todeselectit.TaptheDirectorbuttonagain,and
viewtheDirectorpage.
4 IntheDirectorlistofIPaddresses,taponyour
Controller’sIPaddress.Thescreendisplaysyour
currentconnections(Figure9).
Figure9.ControllerAddress
5 VerifythattheName,IPAddress,anddefault
location(room)displayontheTouchScreento
ensureallofthecorrectconnections.
Configure in Composer
UsingComposerPro,addthedriverforthe7”
PortableTouchScreenwithCameratoyourproject.
SeeComposer Pro Getting Started ontheControl4
Dealerwebsite fordetails.
1 StartComposerandconnecttoaDirector.
2 AddtheTouchScreenobjecttotheproject:
a IntheSystemDesignView(defaultview)
projecttree(leftpane),highlighttheroom
wheretheTouchScreenresides.
5