Installation Guide

6
Configuration
Configure the touchscreen for wireless (optional)
To configure the touchscreen for wireless:
1 After initialization, tap Network. The network configuration
page opens.
2 Under Wi-Fi, tap or slide OFF/ON to enable WiFi, then tap
the Wi-Fi field to open a list of available networks.
3 Tap the network name you want to connect to.
4 Tap the Password field, then use the on-screen keyboard to
type the password (if required).
Note: If you need to enter a static IP address, follow the
instructions under “To set a wireless static IP address”
below before proceeding.
5 Tap Connect.
If you don’t see the network you want:
1 Tap +, then tap the Network SSID field and type the SSID
(name) of the network by using the on-screen keyboard.
2 Tap the Security field, then select the type of security to use.
3 Tap the Password field, then use the on-screen keyboard to
type the password (if required).
Note: If you need to enter a static IP address, follow the
instructions under “To set a wireless static IP address”
below before proceeding.
4 Tap Save. The new network is added to the bottom of the
network list.
To set a wireless static IP address:
1 Scroll down and tap Show advanced options.
2 Tap IPsettings, then tap Static.
3 Select each box one at a time and use the on-screen
keyboard to type the:
• IP address
• Gateway
• Network prefix length
• DNS 1 (preferred)
• DNS 2 (alternate)
Configure the touchscreen for Ethernet
If you want to use DHCP (default) for your Ethernet connection,
no further setup is required.
To configure a static IP address for Ethernet:
1 After initialization, tap Network. The network configuration
page opens.
2 Tap Ethernet. The Ethernet settings screen opens.
3 Tap Static IP Settings, then tap Use static IP.
4 Select each box one at a time and use the on-screen
keyboard to type the IP Address, Gateway, Netmask, DNS 1
(preferred), and DNS 2 (alternate).
5 Tap SAVE when finished.
Add and configure in Composer Pro
After the touchscreen is installed and appears on the home
network, use Composer Pro to add it to the Control4 system and
configure it.
Use the Composer Pro System Design and Connections views to
add and configure this device.
To add and configure a T4 touchscreen to a project:
1 Add the T4 8/10" In-Wall Touchscreen driver to your project.
2 Select the touchscreen or its Intercom component in the
project tree’s System Design view.
3 View and change the properties in the Properties pane as
needed.
Properties include:
• Network Connection—Reports the touchscreen’s current
network connection type.
• Back Light—Use the arrows or type numbers to set the
light level, then click Set.
• Adaptive Brightness Enabled—Enables or disables
adaptive brightness.
Advanced properties include:
• Camera Enabled—Enables or disables the camera.
• Reboot—Remotely reboots the touchscreen.
Intercom (nested under the touchscreen) properties:
• Appearance
• Exclude from Navigator—Select to hide the
touchscreen from appearing in user interfaces as an
available device.
• High Quality Enabled—Select to use the highest
resolution setting for the camera.
• Dial Pad UI Enabled—Enables the on-screen dial pad.
• Behavior
• Select the modes you want this touchscreen to
support: Play Door Chime, Do Not Disturb, Auto
Answer, Send Video, Monitor Mode, Echo Calibration,
Disable Echo Cancellation.
• Audio Control—Select the volume of individual audio
settings.
• Sip Information—Information for integrating the
touchscreen into your SIP/VoIP system.
• Custom Buttons—Select to enable and label the two
available custom buttons
• Alternate Camera—Select to use an external camera for
the video associated with the touchscreen, for example,
a security camera mounted to the side of the person
operating the touchscreen.