User's Guide

Use the System Remote Control
Use with On-Screen Menus
1 To switch to On-Screen mode, press the Display button once or twice
until “Control4 Remote” displays in the LCD.
2 Access the On-Screen menu by pressing .
3 Choose a subsystem to navigate or control by pressing the subsystem’s
button or by scrolling to it with the arrows and pressing Select.
Refer to Control4 On-Screen Menu User Guide for user instructions.
Use to Control Audio and Video Devices
1 To switch to Controller mode, press the related subsytem button twice.
2 In the On-Screen menu, choose the device.
3 Use the supported Controller mode buttons as needed.
FCC and UL Information
FCC ID: R33050110011
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interfence, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION! Changes or modifications not expressly approved by
Control4 could void the user’s authority to operate the equipment.
UL Control number: xxxx
CAUTION! To reduce the risk of overheating and possible damage to
other equipment, Do Not Install to control an Outlet Receptacle, a
Motor-Operated Appliance, a Fluorescent Lighting Fixture, or a
Transformer-Supplied Appliance.
WARNING! This product has NOT been approved for
use with Aluminum wiring.
CE information: (Placeholder...Content here).
Limited 1 Year Warranty
This device has a limited one (1) year warranty on parts from the date of
installation. Control4 will replace or repair any defective unit. Return unit to
the place of purchase for replacement. For any damages incurred, the
warranty will never exceed the purchase price of the device. This warranty
does not cover installation, removal, or reinstallation cost. The warranty is
not valid in cases where damage incurred due to misuse, abuse, incorrect
repair, or improper wiring or installation. It does not cover incidental or
consequential damage. This warranty gives you specific legal rights, and you
might also be entitled to other rights that vary from state to state. Some
states do not allow limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or conseqential damages. In these cases,
the above mentioned limitations might not apply to you. To automatically
receive notification of upgrades, register your device by returning the
enclosed registration card or by going to the MyControl4.com web site.
Control4 Technical Support
For help on the installation or operation of this product, email or call the
Control4 Technical Support Center. Please provide your exact model
number. Contact [e-mail] or see the web site
www.control4.com.
United States Patents
Pending.© 2004 Control4
Technologies.
Made and printed in the United
States.
Part Number: ??-???? Rev 1 Draft 3