User guide

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization NV Media Card
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Unidrive M100 User Guide 73
Issue Number: 1
Parameter ranges and Variable minimum/maximums:
Some parameters in the drive have a variable range with a variable minimum and a variable maximum values which is dependent on one of the
following:
• The settings of other parameters
• The drive rating
• The drive mode
• Combination of any of the above
Relay output 08.008 08.018 08.028
Reset 10.033 10.034 10.035 10.036 10.001
S ramp 02.006 02.007
Sample rates 05.018
Security code 11.030 11.044
Skip speeds 01.029 01.030 01.031 01.032 01.033 01.034 01.035
Slip compensation 05.027 05.008
NV media card 11.036 to 11.040 11.042
Firmware version 11.029 11.035
Reference selection 01.014 01.015 01.049 01.050 01.001
Status word 10.040
Supply 05.005 06.046
Switching frequency 05.018 05.035 07.034 07.035
Thermal protection - drive 05.018 05.035 07.004 07.005 07.035 10.018
Thermal protection - motor 04.015 05.007 04.019 04.016 04.025 08.035
Time - filter change 06.019 06.018 06.021 06.022 06.023
Time - powered up log 06.020 06.019 06.017 06.018
Time - run log 06.019 06.017 06.018
Torque 04.003 04.026
Torque mode 04.008 04.011
Trip detection 10.037 10.038 10.020 to 10.029
Trip log 10.020 to 10.029 10.041 to 10.060 10.070 to 10.079
Under voltage 05.005 10.016 10.015
V/F mode 05.015 05.014
Voltage controller 05.031
Voltage mode 05.014 05.017 05.015
Voltage rating 11.033 05.009 05.005
Voltage supply 06.046 05.005
Warning 10.019 10.012 10.017 10.018 10.040
Zero frequency indicator bit 03.005 10.003
Feature Related parameters (Pr)