User guide

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
NV Media
Card
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
52 Unidrive M100 User Guide
Issue Number: 1
The up and down buttons can only be used to move between menus if
Pr 00.010 has been set to show 'ALL'. Refer to section 5.8 Parameter
access level and security on page 54.
Figure 5-4 Mode examples
1 Parameter view mode: Read write or Read only
2 Status mode: Drive OK status
If the drive is ok and the parameters are not being edited or viewed, the
display will show one of the following:
inh', 'rdy' or status mode parameter value.
3 Status mode: Trip status
When the drive is in trip condition, the display will indicate that the drive
has tripped and the display will show the trip code. For further
information regarding trip codes, refer to section 12.4 Trips, Sub-trip
numbers on page 122.
4 Status mode: Alarm status
During an 'alarm' condition the display flashes between the drive status
parameter value and the alarm.
When changing the values of parameters, make a note of the new
values in case they need to be entered again.
For new parameter values to apply after the line power supply to the
drive is interrupted, new values must be saved. Refer to section
5.6 Saving parameters on page 53.
5.3 Menu structure
The drive parameter structure consists of menus and parameters.
The drive initially powers up so that only Menu 0 can be viewed. The up
and down arrow buttons are used to navigate between parameters and
once Pr 00.010 has been set to 'All' the up and down buttons are used to
navigate between menus.
For further information refer to section 5.8 Parameter access level and
security on page 54.
The menus and parameters rollover in both directions i.e. if the last
parameter is displayed, a further press will cause the display to rollover
and show the first parameter.
When changing between menus, the drive remembers which parameter
was last viewed in a particular menu and thus displays that parameter.
5.4 Menu 0
Menu 0 is used to bring together various commonly used parameters for
basic easy set up of the drive. The parameters displayed in Menu 0 can
be configured in Menu 22.
Appropriate parameters are copied from the advanced menus into Menu
0 and thus exist in both locations.
For further information, refer to Chapter 6 Basic parameters on page 55.
Figure 5-5 Menu 0 copying
Do not change parameter values without careful
consideration; incorrect values may cause damage or a
safety hazard.
NOTE
 
 
3 4
1 2
WARNING
NOTE
NOTE
Menu 0
00.004
00.005
00.006
Menu 2
02.021
Menu 1
11.034
Menu 4
05.007
10
AV
0.00
AV
0.00
10.0