User guide

Safety

information

Product

information

Mechanical

installation

Electrical

installation

Getting

started

Basic

parameters

Running the

motor

Optimization NV Media Card

Advanced

parameters

Technical

data

Diagnostics

UL listing

information

Unidrive M100 User Guide 19

Issue Number: 1

Figure 3-4 Removing the terminal cover

1. Using a flat bladed screwdriver, turn the terminal cover locking clip anti-clockwise by approximately 30°

2. Slide the terminal cover down

3. Remove terminal cover

Figure 3-5 Installing the AI-Backup adaptor

1. Identify the two plastic fingers on the underside of the AI-Backup adaptor (1) - then insert the two fingers into the corresponding slots in the

spring-loaded sliding cover on the top of the drive.

2. Hold the adaptor firmly and push the spring loaded protective cover towards the back of the drive to expose the connector block (2) below.

3. Press the adaptor downwards (3) until the adaptor connector locates into the drive connection below.