User guide

Unidrive SP Short Form Guide 91
Issue Number: 2 www.controltechniques.com
Safety
Information
Product
Information
Mechanical
Installation
Electrical
Installation
Getting Started Basic parameters
Running the
motor
SMARTCARD
Advanced
parameters
Diagnostics
UL Listing
Information
9.11 Menu 11: General drive set-up
Parameter
11.01 Pr 0.11 set up
11.02 Pr 0.12 set up
11.03 Pr 0.13 set up
11.04 Pr 0.14 set up
11.05 Pr 0.15 set up
11.06 Pr 0.16 set up
11.07 Pr 0.17 set up
11.08 Pr 0.18 set up
11.09 Pr 0.19 set up
11.10 Pr 0.20 set up
11.11 Pr 0.21 set up
11.12 Pr 0.22 set up
11.13 Pr 0.23 set up
11.14 Pr 0.24 set up
11.15 Pr 0.25 set up
11.16 Pr 0.26 set up
11.17 Pr 0.27 set up
11.18 Pr 0.28 set up
11.19 Pr 0.29 set up
11.20 Pr 0.30 set up
11.21 Parameter scaling
11.22 Parameter displayed at power-up
11.23 Serial address
11.24 Serial mode
11.25 Baud rate
11.26 Minimum comms transmit delay
11.28 Drive derivative
11.29 Software version
11.30 User security code
11.31 User drive mode
11.32 Maximum heavy duty current rating
11.33 Drive voltage rating
11.34 Software sub-version
11.35 Number of modules
11.36 SMARTCARD parameter data previously loaded
11.37 SMARTCARD data number
11.38 SMARTCARD data type / mode
11.39 SMARTCARD data version
11.40 SMARTCARD data checksum
11.41 Status mode timeout
11.42 Parameter copying
11.43 Load defaults
11.44 Security status
11.45 Select motor 2 parameters
11.46 Defaults previously loaded
11.47 Drive onboard PLC program enable
11.48 Drive onboard PLC program status
11.49 Drive onboard PLC programming events
11.50 Drive onboard PLC program average scan time
11.51 Drive onboard PLC program first run