User guide

42 Unidrive SP Short Form Guide
www.controltechniques.com Issue Number: 2
Figure 5-4 Display modes
* Can only be used to move between menus if L2 access has been enabled
(Pr 0.49). Refer to section 5.11 Parameter access level and security on
page 47.
**Timeout defined by Pr 11.41 (default value = 240s).
Figure 5-5 Mode examples
Use
* keys
to select parameter for editing
To enter Edit Mode,
press key
Status
Mode
(Display
not
flashing)
Parameter
Mode
(Upper
display
flashing)
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values
using keys.
When returning
to Parameter
Mode use the
keys to select
another parameter
to change, if
required
To exit Edit Mode,
press key
To enter Parameter
Mode, press key or
*
Temporary
Parameter
Mode
(Upper display
flashing)
Timeout**
Timeout**
Timeout**
To return to
Status Mode,
press
key
RO
parameter
R/W
parameter
Pr value 5.05
Menu 5. Parameter 5
Trip type (UV = undervolts)
Drive status = tripped
Trip StatusAlarm Status
Parameter
View Mode
Healthy Status
Status Mode
Do not change parameter values without careful consideration; incorrect values may
cause damage or a safety hazard.
WARNING
When changing the values of parameters, make a note of the new values in case they
need to be entered again.
NOTE
For new parameter-values to apply after the AC supply to the drive is interrupted, new
values must be saved. Refer to section 5.7 Saving parameters on page 46.
NOTE