Cut Sheet

SI-PROFINET-V2
SI-PROFINET-V2 allowsthedriveto communicate and interface with PROFINET PLCs and networks.
Features include:
Dual 100 BASE-TX RJ45 connectors with support for shielded twisted pair, full-duplex 100 Mbps connectivity with
auto crossover correction
Integrated switches allow for use of line networks i.e. daisy chaining
Both ports operate in full duplex mode as a network switch PROFINET Real-time class RT_Class_1 and
conformance class A
Cycle times from 2 ms to 512 ms specied during conguration
Automatic device replacement using the LLDP and DCP protocols
LED indication of network port activity
Up to 64 cyclic I/O module slots (maximum of 32 in and 32 out) congured by network conguration tool and
GSDML le Identication and maintenance functions I&M0 to I&M4 supported
Did you nd what you wanted? If not submit a support request using our
technical support ticketing system
(https://support.controltechniques.com/index.php?/techsupport/Inquiry).
Drive Compatibility
The compatibility table below highlights which Control Techniques drives support th
Commander
C200 (/en-
us/drives/control-
techniques/products/ac-
drives/commander-c-
general-purpose-drives)
Commander
C300 (/en-
us/drives/control-
techniques/products/ac-
drives/commander-c-
general-purpose-drives)
Unidrive
M400 (/en-
us/drives/control-
techniques/products/ac-
drives/unidrive-
m/unidrive-m400)
Unidrive
M600 (/en-
us/drives/control-
techniques/products/ac-
drives/unidrive-
m/unidrive-m600)
u
tech
m
√ √ √ √
SI-PROFINET-V2
SI-PROFINET-V2 can be used to communicate and interface with PROFINET PLCs and networks
Downloads
–