User manual

IEC61131 User and Reference Manual
April 22, 2008
534
The Allow Duplicate Modbus Addresses checkbox determines if the Modbus I/O database
addresses assigned to the DNP data points must be unique. Check this box if you want to allow more
than one point to use the same Modbus address.
Click the OK button to accept the 16-Bit Analog Output parameters and close the DNP Settings
dialog.
Click the Cancel button to close the dialog without saving any changes.
Click the Add button to add the current 16-Bit Analog Output to the DNP configuration.
Click the Copy button to copy the current 16-Bit Analog Output parameters to the next DNP
Address.
Click the Delete button to delete the current 16-Bit Analog Output.
Click the Move Up button to move the current 16-Bit Analog Output up one position in the tree
control branch.
Click the Move Down button to move the current 16-Bit Analog Output down one position in the
tree control branch.
32-Bit Analog Outputs Configuration
The 32-Bit Analog Outputs property page is selected for editing by clicking 32-Bit Analog Outputs
in the tree control section of the DNP Settings window. When selected the 32-Bit Analog Outputs
property page is active.
32-Bit Analog Outputs parameters are viewed in this property page.
The Number of Points displays the number of 32-Bit Analog Outputs reported by this RTU. This
value will increment with the addition of each configured 32-Bit Analog Output point. The