User manual

IEC61131 User and Reference Manual
April 22, 2008
519
 00001 through 09999
The Control Type parameter specifies whether the Binary Output is a paired control or not. If it is a
paired control, i.e. trip/close output type, this means that the DNP address is associated to two
physical control outputs and requires two Modbus addresses per DNP address. Control type
selections are:
 Paired
 Not Paired
The Allow Duplicate Modbus Addresses checkbox determines if the Modbus I/O database
addresses assigned to the DNP data points must be unique. Check this box if you want to
allow more than one point to use the same Modbus address.
Click the OK button to accept the Binary Output parameters and close the DNP Settings dialog.
Click the Cancel button to close the dialog without saving any changes.
Click the Add button to add the current Binary Output to the DNP configuration.
Click the Copy button to copy the current Binary Output parameters to the next DNP Address.
Click the Delete button to delete the current Binary Output.
Click the Move Up button to move the current Binary Output up one position in the tree control
branch.
Click the Move Down button to move the current Binary Output down one position in the tree
control branch.
16–Bit Analog Inputs Configuration
The 16-Bit Analog Inputs property page is selected for editing by clicking 16-Bit Analog Inputs in
the tree control section of the DNP Settings window. When selected the 16-Bit Analog Inputs
property page is active.