User manual

IEC61131 User and Reference Manual
April 22, 2008
516
 00001 through 09999
 10001 through 19999
The Class of Event Object parameter specifies the event object class the Binary Input is assigned.
The selections are:
 None
 Class 1
 Class 2
 Class 3
The Debounce parameter limits the frequency of change events. The input must remain in the same
state for the debounce time for a change of state to be detected. Note that the input is sampled every
0.1s. Changes shorter than the sample time cannot be detected. Valid values are 0 to 65535 tenths of
seconds. The value 0 means no debounce. The default value is 0.
The Allow Duplicate Modbus Addresses checkbox determines if the Modbus I/O database
addresses assigned to the DNP data points must be unique. Check this box if you want to allow more
than one point to use the same Modbus address.
Click the OK button to accept the Binary Input parameters and close the DNP Settings dialog.
Click the Cancel button to close the dialog without saving any changes.
Click the Add button to add the current Binary Input to the DNP configuration.
Click the Copy button to copy the current Binary Input parameters to the next DNP Address.
Click the Delete button to delete the current Binary Input.
Click the Move Up button to move the current Binary Input up one position in the tree control
branch.
Click the Move Down button to move the current Binary Input down one position in the tree control
branch.
Binary Outputs Configuration
The Binary Outputs property page is selected for editing by clicking Binary Outputs in the tree
control section of the DNP Settings window. When selected the Binary Outputs property page is
active.