User manual

IEC61131 User and Reference Manual
April 22, 2008
515
Adding Binary Inputs
Binary Inputs are added to the DNP configuration using the Binary Input property page. To add a
Binary Input:
 Select Binary Inputs in the tree control section of the DNP Settings window.
 Click the Add button in the Binary Inputs property page.
 The Binary Input property page is now displayed.
 Edit the Binary Input parameters as required and then click the Add button.
As Binary Inputs are defined they are added as leaves to the Binary Inputs branch of the tree control.
When Binary Inputs are defined the Binary Inputs branch will display a collapse / expand control to
the left of the branch. Click this control to display all defined Binary Inputs.
The Binary Input parameters are described in the following paragraphs.
The DNP Address window displays the DNP Binary Input address of the point. Each Binary Input is
assigned a DNP address as they are defined. The DNP point address starts at the value defined in the
Binary Inputs configuration dialog and increments by one with each defined Input.
The Modbus Address parameter specifies the Modbus address of the Binary Input assigned to the
DNP Address. The SCADAPack and Micro16 controllers use Modbus addressing for all digital
inputs. Refer to the I/O Database Registers section of the TelePACE Ladder Logic Reference and
User Manual for complete information on digital input addressing in the SCADAPack and Micro16
controllers. Valid Modbus addresses are: