User manual

IEC61131 User and Reference Manual
April 22, 2008
489
When best to use
Master in a Point
to Multipoint
network
Data Concentrator
with many outstations
that will take a while
to configure. When
outstation data does
not need to be
available to logic in
this node.
When remote
DNP data is
needed by local
program
Strictly
Repeater
Forms basic
node in DNP
network.
DNP Configuration Menu Reference
This section of the manual details the SCADAPack DNP3 driver configuration parameters. The
DNP Configuration panel is accessed from the Controller | DNP Configuration menu from either
TelePACE or ISaGRAF. Browse through this chapter to familiarize yourself with some key DNP3
concepts and their implementation in a SCADAPack controller.
When selected the DNP Settings window is opened, as shown below.
The DNP Settings window has a tree control on the left side of the window. The tree control appears
differently depending on the controller type selected. The SCADAPack 330/334, SCADAPack 350,
SCADAPack 32 and SCADAPack 32P controllers support DNP master and include the bolded items