User manual

IEC61131 User and Reference Manual
April 22, 2008
458
Enable DNP on Communication Interface
The first step recommended in configuration the DNP driver on a SCADAPack controller is to
enable DNP on the communication interface. To enable the DNP protocol on com2,
1. From the Controller menu in either TelePACE or ISaGRAF, select Serial Ports.
2. Select COM2 from the Port drop down list.
3. Set the Protocol type to DNP.
4. Click on OK.
5. If using an Ethernet equipped controller, enable DNP in TCP or DNP in UDP from the Controller
IP configuration dialog.