User manual

IEC61131 User and Reference Manual
April 22, 2008
444
2. Right click your Dial-up Connection icon that was setup in the previous section and
select Connect from the list. A prompt for username and password is displayed.
3. Enter a valid PAP or CHAP username and password. Valid usernames and passwords
are configured on the PPP Login page of the Controller IP Configuration dialog and must
be downloaded to the SCADAPack 32. Then select the Dial button. If neither PAP nor
CHAP is being used, ignore the prompt and just select the Dial button.
4. A progress message is displayed. If the connection is successful your Dial-up
Connection icon should display the word Connected in the Status column.
5. You may now connect to the IP address assigned to SCADAPack 32 PPP serial port
using an appropriate application and a supported protocol (e.g. Modbus/TCP). In the
example below, Firmware Loader is used to connect over PPP to the SCADAPack 32.
From the PC Communication Settings dialog, the IP address assigned to the
SCADAPack 32 PPP serial port is selected as the Connect to Host.