User manual

IEC61131 User and Reference Manual
April 22, 2008
443
12. Uncheck all components except the component Internet Protocol (TCP/IP). Select the
component Internet Protocol (TCP/IP) and select the Properties button. The Internet
Protocol (TCP/IP) Properties dialog is displayed.
13. The SCADAPack 32 does not have a DHCP server to automatically provide an IP
address. Instead the PC‟s serial port must be given a fixed IP address to use for PPP
connections. Select the option Use the following IP address. Enter an IP address to
assign to your PC‟s serial port. Obtain this IP address from your Network Administrator.
Then select OK to return to the Properties dialog.
14. Select OK again to close the dialog.
Making a PPP Dial-up Connection to the SCADAPack 32 using Windows 2000
A connection can only be made after successfully setting up a Dial-up Connection icon as
described in the section Connection Setup above. Also, a serial port on the SCADAPack 32
must already be configured for the PPP protocol using the Controller IP Configuration dialog
and must be downloaded to the SCADAPack 32.
1. From the Start menu, right click Network and Dial-up Connections from the Settings
group, and select Open. The Network and Dial-up Connections dialog is displayed.