User manual

IEC61131 User and Reference Manual
April 22, 2008
18
Note: Hardware Keys used with ISaGRAF 3.32 are not supported by ISaGRAF 3.5. A
replacement Hardware Key or Software License must be obtained.
4. Existing projects and any restored projects must be recompiled completely:
Open the project and select Touch from the Make menu on the Programs dialog.
This will select a full make the next time Make application is selected.
Select Make application from the Make menu.
Un-installing ISaGRAF 3.32
This choice requires that all projects be archived first. Note that archived projects cannot be
restored with a Demo License in ISaGRAF 3.5. A permanent license is required to restore
projects.
1. Archive all projects that you wish to keep by selecting Archive from the Tools menu on
the Project Manager dialog.
2. Un-install ISaGRAF Extensions from the Control Panel.
3. Delete the directory C:\ISAWIN where ISaGRAF 3.32 was installed.
4. Install ISaGRAF Workbench 3.5.
5. Install ISaGRAF Extensions. Any version of the Extensions may be installed with
ISaGRAF 3.5.
6. ISaGRAF will run in demo mode for 30 days. Use a Hardware license key or select
Licensing from the ISaGRAF 3.5 program group to enable a permanent software
license.
Note: Hardware Keys used with ISaGRAF 3.32 are not supported by ISaGRAF 3.5. A
replacement Hardware Key or Software License must be obtained.
7. Any restored projects must be recompiled completely:
Open the project and select Touch from the Make menu on the Programs dialog.
This will select a full make the next time Make application is selected.
Select Make application from the Make menu.
Restoring ISaGRAF 3.3 Projects into ISaGRAF 3.5
When upgrading to ISaGRAF 3.5 you may at some point need to restore into ISaGRAF 3.5 a
project that was archived in ISaGRAF 3.32. If an attempt is made to enter Debug mode with
a restored ISaGRAF 3.32 project, the following error message box is displayed:
The message indicates that he project must be recompiled. Once this is done the project can
be downloaded and will then run correctly.
To re-make the entire project: