User manual

IEC61131 User and Reference Manual
April 22, 2008
138
dlogcnfg, flow, and total when these are used in the IEC-61131 application. This memory
is also used by a C/C++ application when the function allocateMemory() is called (e.g. the
Flow Computer application).
Memory Remaining – describes the unused memory available to all programs.
Options Command
The Options command sets workbench options unique to Control Microsystems. The
Options command is selected from the Workbench selection in the Tools menu of the
Programs window. When selected this command opens the Workbench Options dialog.
The Check Dictionary for Address Conflicts check-box selects if additional checks are
performed on the dictionary for address conflicts. When selected this check is done each
time the dictionary is saved. If a conflict has been detected during the check the Conflict
Table is displayed. Refer to the Conflict Table section below for further details.
The Hang up when debugger exits check-box selects if dial-up connections are closed
when the debugger exits. If selected, exiting the debugger will hand up the phone. If not
checked, the phone is left connected. To disconnect, select Disconnect from Controller on
the Controller menu. This is useful if you are often switching from the debugger to the editor
on a dial-up connection.
The OK button saves the settings to the configuration file and closes the dialog.
The Cancel button closes the dialog and discards the changes.
Conflict Table
When the Check Dictionary for Address Conflicts check-box has been selected and a
conflict is found the Conflict Table is displayed showing the conflicting addresses and
variables. An example of a Conflict Table is shown below.
The OK button closes the dialog.