User manual

IEC61131 User and Reference Manual
April 22, 2008
132
The C/C++ Program Loader dialog presented is the same for all controller types. For all
controllers except the SCADAPack 330/334 or SCADAPack 350, this dialog may be used to
load, run, stop or delete just one C/C++ program.
SCADAPack and SCADAPack 32 Controllers
The dialog shown below appears when the C/C++ Program Loader command is selected
from the controller menu and the Controller Type is either a SCADAPack32 or any one of the
SCADAPack series of controllers (Micro16, SCADAPack, SCADAPack Light, SCADAPack
Plus, SCADAPack 100 and SCADASense series of controllers) but not a SCADAPack
330/334, SCADAPack 350 or SCADASense 4203.
For all controllers except the SCADAPack 330/334, SCADAPack 350 and the SCADASense
4203 the C/C++ Program Loader dialog may be used to load just one C/C++ program.
The dialog displays the status of the C/C++ Program if one has been loaded in the controller.
The status of the program is indicated as Running or Stopped. The list is empty if there is
no C/C++ Program loaded in the controller.
The Close button closes the dialog.
The Add button writes a C/C++ program to the controller. Selecting the Write button opens
the Add C/C++ Program dialog.
The Run button stops and restarts the C/C++ program in the controller.
The Stop button stops the selected C/C++ program in the controller.
The Delete button stops and erases the selected C/C++ program in the controller.
The Run, Stop and Delete buttons are disabled if there is no C/C++ program loaded in the
controller.
The Reset button resets the controller. A reset restarts the controller processor, the C/C++
program and the Ladder Logic program.
The Refresh button refreshes the status of the loaded C/C++ program.
Add C/C++ Program Dialog
The Add C/C++ Program dialog writes a C/C++ Program to the controller.