User manual

IEC61131 User and Reference Manual
April 22, 2008
126
DNP in UDP
The DNP in UDP property page is selected for editing by DNP in UDP in the tree control
section of the IP Configuration dialog. When selected the DNP in UDP property page is
active.
The Protocol selection selects whether the DNP in UDP protocol is enabled. If this option is
enabled the controller supports DNP in UDP protocol. Disabling this option prevents the
controller from processing DNP in UDP protocol messages and sending DNP in UDP master
messages. The default selection is disabled.
The UDP Port sets the port used by the DNP in UDP protocol. Valid port number range is 1
to 65534. The default value is 20000. Consult your network administrator to obtain a port if
you are not using the default.
Friendly IP List
The Friendly IP property page is selected for editing by Friendly IP in the tree control section
of the IP Configuration dialog.