User manual

IEC61131 User and Reference Manual
April 22, 2008
115
Controller IP
When the IP Configuration menu item is clicked under the Controller menu the IP
Configuration dialog is opened. This dialog is available only when the controller type is set to
SCADAPack 330/334, SCADAPack 350, SCADAPack 32 or SCADAPack 32P.
The IP Configuration dialog has a tree control on the left side of the window. The
SCADAPack 32 and SCADAPack 32P support Point-To-Point Protocol (PPP) on the serial
ports. The tree control displays headings for com 1 Port through com 4 Port and PPP Login
are displayed for configuring the serial ports for PPP. The SCADAPack 330/334 and
SCADAPack 350 do not support PPP on the serial ports and the headings for com 1 Port
through com 4 Port and PPP Login are not displayed.
Each of the tree control selections is explained in the following sections of this user manual.
This tree control for the SCADAPack 32 and SCADAPack 32P contains headings for:
 LAN Port
 com 1 Port
 com 2 Port
 com 3 Port
 com 4 Port
 PPP Login
 Modbus Common
 Modbus/TCP
 Modbus RTU in UDP
 Modbus ASCII in UDP
 DNP in TCP
 DNP in UDP
 Friendly IP List
This tree control for the SCADAPack 330/334 and SCADAPack 350 contains headings for:
 LAN Port
 Modbus Common
 Modbus/TCP
 Modbus RTU in UDP
 Modbus ASCII in UDP
 DNP in TCP
 DNP in UDP
 Friendly IP List
When a tree control is selected by clicking the mouse on a heading, a property page is
opened for the header selected. From the property page the IP configuration parameters for
the selected header is displayed.
The Default button selects the default values for the current property page.
The OK button saves the configuration and closes the Controller IP Configuration dialog.
The Cancel button closes the Controller IP Configuration dialog without saving any changes.