User manual

IEC61131 User and Reference Manual
April 22, 2008
98
Controller Menu Commands
Controller and Option commands are specific to the operation of SCADAPack controllers.
These commands are selected from the menu bar in the ISaGRAF Workbench Programs
window.
Operating parameters are configured using selected controller commands. Controller
commands are selected from the Controllers selection in the Tools menu of the Programs
window.
Controller parameters such as serial port settings, initialization, I/O error indication and
controller locking functions are configured using controller commands. Control of the
connection and disconnection of dialup modem communication links and reading and writing
parameters to the controller are also executed using controller commands.
Controller Type
The Controller Type dialog allows selection of the current controller type from a drop down
list. Selecting a controller type will change the default and available settings displayed on the
Serial Ports dialog as well as enable or disable IP Configuration dialog where applicable.
Available hardware types in the list are:
The controller types available for selection are:
 Micro16
 SCADAPack
 SCADAPack PLUS
 SCADAPack LIGHT
 SCADAPack LP
 SCADAPack 32
 SCADAPack 32P
 SCADAPack 100: 256K: This controller type can only be used when the controller
firmware is version older than 1.80 and the controller ID is less than or equal to
A182921.
 SCADAPack 100: 1024K: This controller type can only be used when the controller
firmware is version 1.80 or newer and the controller ID is greater than or equal to
A182922.
 SCADASense 4202 DR
 SCADASense 4202 DS
 SCADAPack 350
 SCADASense 4203 DR
 SCADASense 4203 DS
 SCADAPack 330