Hardware manual

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
54
Reporting Current or Selected Values
Command: +GCI?
Response: +GCI: nn
Example: +GCI: 3D indicates that the modem is set for France.
Reporting Supported Range of Parameter Values
Command: +GCI=?
Response: +GCI: (nn[,nn[,nn].......]]
Example: +GCI: (20,73,B5) The modem can be set for Canada, Mexico or the United States.
10.4.15 +GMI - Request Manufacturer Identification
This command causes the modem to report the modem product manufacturer.
Command: +GMI
Typical Response: +GMI: ROCKWELL
OK
10.4.16 +GMM - Request Model Identification
This command causes the modem to report the modem product.
Command: +GMM
Typical Response: +GMM: V90
10.4.17 +GMR - Request Revision Identification
This command causes the modem to report the modem version, revision level or date. This is the
same as the I3 command.
Command: +GMR
Typical Response: +GMR: V3.001-V90_2M_DLS
OK
10.4.18 +IFC=n - DTE-Modem Local Flow Control
This extended-format compound parameter controls the operation of local flow control between the
DTE and the modem during the data state when V.42 error control is used, or when fallback to non-
error control mode is specified to include buffering and flow control. It accepts two numeric
subparameters.
Command: +IFC=[m[,n]]
m = Specifies the method to be used by the DTE to control the flow of received data from the
modem.
0 None.
1 XON/XOFF on transmitted data (XON/XOFF on transmit data); do not pass
XON/XOFF characters to the remote modem.