Hardware manual

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
51
10.4.11 +ETBM=x,y,z - Call Termination Buffer Management
This extended-format compound parameter controls the handling of data remaining in modem
buffers upon call termination. It accepts three numeric subparameters:
Command: +ETBM=[x[,y[,z]]]
x Decimal number 0 specifying that disconnect will occur immediately and all buffered
transmit data will be discarded when the local DTE requests call disconnection.
y Decimal number 0 specifying that disconnect will occur immediately and all buffered
receive data will be discarded when the local DTE requests call disconnection.
Z Decimal number 0 specifying that the modem will not attempt to deliver the buffered data
before abandoning the attempt and discarding remaining data.
Reporting Current or Selected Values
Command: +ETBM?
Response: +ETBM: x,y,z
Example: +ETBM: 0,0,0
Reporting Supported Range of Parameter Values
Command: +ETBM=?
Response: +ETBM: (x range),(y range), (y range)
Example: +ETBM: (0),(0),(0)
10.4.12 +FCLASS=n - Select Active Service Class
This command selects the active service class.
+FCLASS=0 Select Data Mode (see Section 3) (Default.)
+FCLASS=1 Select Facsimile Class 1 Mode (see Section 4)
+FCLASS=1.0 Select Facsimile Class 1.0 Mode (see Section 4)
+FCLASS=2 Select Facsimile Class 2 Mode (see Section 5)
+FCLASS=8 Select Voice Mode (see Section 6)
+FCLASS=80 Select VoiceView Mode (see Section 6)
Result Codes:
OK For n = 0, 1, 1.0, 2, 8, and 80.
ERROR Otherwise.
Reporting Current or Selected Values
Command: +FCLASS?