Hardware manual

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
40
&T0 Terminates test in progress. Clears S16.
&T1 Initiates local analog loopback, V.54 Loop 3. Sets S16 bit 0. If a connection exists when this
command is issued, the modem hangs up. The CONNECT XXXX message is displayed
upon the start of the test.
10.3.13 &V - Display Current Configuration and Stored Profiles
This command reports the current (active) configuration, the stored (user) profiles, and the first four
stored telephone numbers. The stored profiles and telephone numbers are not displayed if the
NVRAM is not installed or is not operational as detected by the NVRAM test during reset
processing.
Result Code: OK
Example:
AT&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0 &Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030 S08:002 S09:006 S10:014
S11:255 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020 S46:138 S48:007 S95:000
STORED PROFILE 0:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
S00:002 S02:043 S06:002 S07:030 S08:002 S09:006 S10:014 S11:095 S12:050 S18:000 S36:007
S37:000 S40:105 S41:003 S46:138 S95:000
STORED PROFILE 1:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
S00:002 S02:043 S06:002 S07:030 S08:002 S09:006 S10:014 S11:095 S12:050 S18:000 S36:007
S37:000 S40:105 S41:003 S46:138 S95:000
TELEPHONE NUMBERS:
0 = 1 =
2 = 3 =
OK
10.3.14 &V1 - Display Last Connection Statistics
Displays the last connection statistics in the following format (shown with typical results):
TERMINATION REASON………LOCAL REQUEST
LAST TX rate....………….......… 26400 BPS
HIGHEST TX rate..........………. 26400 BPS
LAST RX rate..............…………. 49333 BPS
HIGHEST RX rate..........………. 49333 BPS
PROTOCOL.................………… LAPM