Hardware manual

5901 High Speed Dialup Modem Hardware Manual

October 19, 2007

This command may not be permitted in some countries. (See P.)

Result Code: OK

10.2.17 Vn - Result Code Form

This command selects the sending of short-form or long-form result codes to the DTE. The

parameter, if valid, is written to S14 bit 3.

V0 Enables short-form (terse) result codes. Line feed is not issued before a short-form result

code.

V1 Enables long-form (verbose) result codes. (Default.)

Result Codes:

OK n = 0 or 1.

ERROR Otherwise.

10.2.18 Wn - Connect Message Control

This command, in conjunction with S95 bits 0, 2, 3, and 5 (bits 2, 3, and 5 can be written directly by

the host or by the +MR, +ER, and +DR commands, respectively), control the format of CONNECT

messages. The actual result code messages reported reflect the W command setting and the S95 bit

settings. (Also see +MR, +ER, and +DR commands.)

The W parameter value, if valid, is written to S31 bits 2 and 3.

W0 Upon connection, the modem reports only the DTE speed (e.g., CONNECT 19200).

Subsequent responses are disabled. (Default.)

W1 Upon connection, the modem reports the line speed, the error correction protocol, and the

DTE speed, respectively. Subsequent responses are disabled.

W2 Upon connection, the modem reports the DCE speed (e.g., CONNECT 14400). Subsequent

responses are disabled.

Result Codes:

OK n = 0, 1, or 2.

ERROR Otherwise.

10.2.19 Xn - Extended Result Codes

This command selects the subset of the result code messages used by the modem to inform the DTE

of the results of commands.

Blind dialing is enabled or disabled by country parameters. If the user wishes to enforce dial tone

detection, a "W" can be placed in the dial string (see D command). The information below is based

upon the default implementation of the X results table.

If the modem is in facsimile mode (+FCLASS=1, 1.0, or 2), the only message sent to indicate a

connection is CONNECT without a speed indication.

X0 Disables reporting of busy tones unless forced otherwise by country requirements; send only

OK, CONNECT, RING, NO CARRIER, ERROR, and NO ANSWER result codes. Blind

dialing is enabled/disabled by country parameters. If busy tone detection is enforced and

busy tone is detected, NO CARRIER will be reported. If dial tone detection is enforced or