Hardware manual

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
31
I1 Reports the least significant byte of the stored checksum in decimal. Reports 255 if the
prestored checksum value is FFh.
I2 Reports "OK".
I3 Reports identification codes in the form VX.X-F_A where:
VX.X = Firmware version (e.g., V3.00)
F = Firmware model and ROM size:
V90 or V34 = V90 or V34 in 1M ROM
V90_2M or V34_2M = V90 or V34 in 2M ROM
A = Application
DLS = Desktop Serial
DLP = Desktop Parallel
DLL = Low Power PC Card
DL3 = Low Power 3V
DLG = Low Power World Class
Example: V3.000-V90_2M_DLS
Note: If RPI+ is enabled (see +Hn command), “Rockwell RPI ™” is appended.
I4 Reports OEM defined identifier string in either Hayes-compatible binary format (default) or
ASCII format (selectable by ConfigurACE), e.g.:
a007840284C6002F
bC60000000
r1005111151012000
r3000111170000000
I5 Reports Country Code parameter (see +GCI command), e.g., B5.
I6 Reports modem data pump model and internal code revision, e.g.,
RCV56DPF-PLL L8571A Rev 29.00/29.00
I7 Reports OK.
Result Codes:
OK n = 0 to 7.
ERROR Otherwise.
10.2.10 L – Speaker Volume
This command sets the speaker volume control. The parameter value, if valid, is written to S22 bits
0 and 1.
L0 Low volume.
L1 Low volume. (Default.)