User Guide
Quick Guide - iDTouch - Version 1.5 - Control iD 2021©
3.
3.1.
⚠
⚠
3.2.
4.2.
4.3.
4.4.
5.
⚠ Cable colors refer to iDTouch.
⚠
⚠
iDTouch - Quick Gu ide
Thank you for purchasing the iDTouch Access Control
www.controlid.com.br/en/access-control/idtouch/
www.controlid.com.br/legal/acessoeponto.pdf
1. Material Required
supply of at least 1A.
2.
• No objects should be less than 20 cm away
from the sides of the equipment.
•
equipment so as not to impair the reach of the
proximity card reader. In case this is not
•
range of 1.00 m and 1.40 m from the ground.
•
3. Completely insert the bushings into the
holes made
monitoring.
An external Wiegand card reader can be connec-
ted to Wiegand inputs WIN0 and WIN1. In case there
controller.
4.
4.1.
by performing the following steps
3. The Green LED will be blinking
4. Enter the programming password
5. The Green LED will be on
7. A long beep indicates successful programming
6. Approach the card to be registered
7. A long beep indicates successful
programming
Wiegand protocol.
It is also possible to connect the iDTouch to one of
the inputs on a controller board or access controller.
model.
To install an electromagnet lock together with the
Controller