Owner manual

TRACEABLE

CONTINUOUS

VISUAL ALARM

TIMER

INSTRUCTIONS

STOPWATCH (COUNT-UP) TIMING

1. If the timer is running, press the START/STOP button

and then press the  and  buttons simultaneously.

The display should read 00 00.

2.PresstheSTART/STOPbuttontobegincount-up

timing.

Note:Duringtherst99minutes59secondsofcount-up

time, the resolution is 1 second, after 100 minutes,

  thecount-upresolutionis1minute.

3. When timing has been completed and the timing has

been stopped, press the  and  buttons

simultaneously to clear the display to zero.

TIMEOUT

The timer may be stopped during any running time by

pressing the START/STOP button. Timing may be resumed

by pressing the START/STOP button a second time.

ALL OPERATIONAL DIFFICULTIES

If this timer does not function properly for any reason,

replace the batteries with new high quality batteries (see

“Battery Replacement” section). Low battery power can

occasionally cause any number of “apparent” operational

difculties.Replacingthebatterieswithanewfresh

batterywillsolvemostdifculties.

BATTERY REPLACEMENT

Anincorrectdisplay,nodisplayoroperationaldifculties

indicate that the batteries should be replaced. Slide open

the battery cover on the back of the timer. Insert two

new AAA size batteries. Make certain to note the proper

polarity as indicated by the diagram in the battery com-

partment. Do not mix new batteries and old batteries.

Replace the battery cover.

WARRANTY, SERVICE, OR CALIBRATION

For warranty, service, or calibration contact:

CONTROL COMpANy

4455RexRoad•Friendswood,Texas77546•USA

Ph.281482-1714•Fax281482-9448

www.control3.com•sales@control3.com

ControlCompanyisISO9001Quality-CertiedbyDNVand

ISO17025accreditedasaCalibrationLaboratorybyA2LA

Traceable

is a registered trademark of Control Company.