Owner`s manual

TELECHIEF
®
SERIES TM2000 / TM4000 / TM6000 OWNER’S MANUAL
4.2.2 Normally Open / Normally Closed Setup
The TeleChief
®
Series provides 2 different outputs for the R0/START relay: N.O. and N.C. The
N.O. is the default setting. If an N.C. output is necessary, please remove the No. 8 wire (RO/Start)
from the connector and insert it into No. 10 as shown in steps 1 through 4 below:
NC Procedure:
4.3 Receiver Installation
TeleChief® Series Receive
r
1. Turn off main power to the crane/machine.
2. Locate a proper place for the receiver.
a. Select a stable place free from electrical noise,
vibration, excessive heat, etc.
b. Select a location that is visible from the operator’s
location.
c. Select a location at least 3 feet away from motors,
relays, power cables, and frequency converters.
d. Keep away from high voltage wiring and devices.
Minimum of 3 feet separation
e. The receiver box must be at least 1.5” (4cm) from
other obstacles.
3. Drill four (4) 6 mm holes for the receiver mounting the unit
with the included hardware.
4. Connect wires to the control circuit of the crane/machine
according to the wiring diagram of the receiver. (Shown in
Section 4.3.1)
5. Secure the cable between the receiver and the machine so that the cable sheath will not wear out due
to vibration.
6. Complete Section 4.5 and test every function of the radio control making sure all motors are correct.
7. Secure the cover making sure not to pinch any wires between the case and the lid.
8. This completes the receiver installation.
MOTOR
Frequency
Converter
Cable
95-00-0-036 Rev D 7 Control Chief Corporation