Owner`s manual

TELECHIEF
®
SERIES TM2000 / TM4000 / TM6000 OWNER’S MANUAL
2.2 Symbols
1. This product and related documentation must be reviewed for familiarization with safety markings and
instructions before operation. This product requires strict adherence to instructions in order to ensure
operational safety. The following symbols may be found on the remote control or throughout the remote
control documentation. Their purpose is to alert you to potentially dangerous situations.
Refer To Manual
When the product is marked with this symbol refer to the instruction manual for additional
information.
High Voltage
Indicates presence of hazardous voltage. Unsafe practice could result in severe personal injury.
Protective Earth Ground
Indicates protective earth terminal.
Warning
Denotes hazard. Included text will give proper instructions. Failure to follow instructions could
result in severe personal injury and/or property damage.
Caution
Denotes hazard. Included text will give proper instructions. Failure to follow instructions could
result in minor personal injury and/or property damage.
2.3 Warnings
1. Read this manual carefully before operating and installing this product.
2. Due to the complex nature of equipment, it is necessary to read the entire manual before installation.
3. Only authorized personnel should service this equipment. Unauthorized work on this unit will void the
warranty.
4. This manual is for reference only; please call your distributor or Control Chief if further assistance is
required.
5. The equipment has been tested for correct operation before delivery from the factory. However, it must
not be used in critical or hazardous operation where incorrect operation may cause personal or
equipment damage.
6. After daily operation, please shut off main power in crane/machine and the power to the receiver.
7. Transmitter should be placed in a safe place when not in use to avoid accidental pressing of buttons.
8. The crane/machine should be equipped with mainline contactor, limit switches, and other required safety
devices as dictated by CMAA, OSHA, or all other applicable governing regulations.
9. The GND (ground) of receiver must be connected to ground of crane/machine, or electrical shock can
occur.
10. Do not use this device during electrical storms or under conditions of electrical interference.
11. Ensure transmitter batteries are in good condition and power for receiver is correct.
12. Installation and maintenance should be done only while the crane/machine’s main power and receiver’s
power are off and locked out to prevent electrical shock.
13. Contents of the manual may be amended by the manufacturer without notice.
95-00-0-036 Rev D 4 Control Chief Corporation