Owner`s manual

TELECHIEF
®
SERIES TM2000 / TM4000 / TM6000 OWNER’S MANUAL
6. Aisles between equipment, stock, etc., should be free of obstructions so the radio control operator can
move freely. These aisles should meet local regulations.
7. Radio controlled operators should always position themselves for the best view of the equipment they are
controlling. The equipment should never be operated blindly. The operator should always remain at a safe
distance, without losing line of sight with the equipment.
8. Transmitter switches should never be mechanically blocked ON or OFF for any equipment motion. When
not in use turn the transmitter off (STOP).
9. After daily operation, shut off main power in crane/machine and the power to the receiver. A secure
storage space should be designated for the transmitter unit especially when not in use. This precaution is
intended to prevent unauthorized use of the equipment.
10. The equipment operator should keep all body parts away from any moving parts and should never be
positioned under a lifted load. Do not make a lift or move a load if anyone is in a location where they could
be struck by the crane/equipment or the load.
11. If the equipment fails to respond properly, the crane/equipment operator should stop operation, turn the
transmitter off (STOP). The operator should immediately report the condition to his/her supervisor.
12. The crane/equipment operator should turn off the transmitter and take it with him/her when and if
boarding the equipment.
13. Remote control operation should NEVER be used for “people moving” applications. Never use remote
operation if there are people aboard the controlled equipment. The remote control operator should NEVER
“ride” on the controlled equipment.
WARNING
ALWAYS PLACE CRANE/EQUIPMENT IN MANUAL OPERATION AND SECURE THE WIRELESS
REMOTE CONTROL TRANSMITTER PRIOR TO PERFORMING ANY MAINTENANCE.
14. The equipment has been tested for correct operation before delivery from the factory. However, it must
not be used in critical or hazardous operation where incorrect operation may cause personal or equipment
damage. If the equipment fails to respond or behaves improperly, the equipment operator should NOT
operate the equipment AND should notify his/her supervisor immediately. When serious conditions are
noticed (conditions that make the crane/equipment unsafe to operate), the equipment should be shut down
immediately and the supervisor notified.
CAUTION
THE RECEIVER UNIT OR RELAYS ARE NOT RATED AS EXPLOSION PROOF. THE RECEIVER UNIT
MUST NOT BE INSTALLED OR OPERATED IN EXPLOSIVE ENVIRONMENTS UNLESS APPROPRIATE
SECONDARY ENCLOSURE MEASURES ARE TAKEN.
WARNING
THE UNIT MUST BE WIRED TO THE CORRECT VOLTAGE; FAILURE TO DO SO MAY DAMAGE THE
SYSTEM.
NOTE
IN AN EMERGENCY, PUSH “STOP” TO STOP RADIO REMOTE CONTROLLED EQUIPMENT.
95-00-0-036 Rev D 3 Control Chief Corporation