Owner`s manual

TELECHIEF
®
SERIES TM2000 / TM4000 / TM6000 OWNER’S MANUAL
5.0 Operation
5.1 Standard Operation
1. Turn-on the main power switch of the equipment.
2. Install two (2) AA size alkaline batteries in the transmitter.
3. Press the Start/RO pushbutton to turn on the main relay inside the receiver.
4. Operate normally according to the function settings.
5. Please perform the following procedure when done operating
a. Press STOP pushbutton
b. Place the transmitter in safe storage location
6. Turn off the main power switch to the equipment
5.2 Emergency Operation
In case of any emergency please:
1. Press STOP pushbutton.
2. Switch off the main power of crane/machine. If the problem persists, contact your local distributor for
service.
6.0 Basic Troubleshooting and Maintenance
6.1 General Precautions
Daily inspection is important and will ensure safe operation. Inspection should include testing the emergency
stop and other safety devices and functions. If there is any doubt, operation must be stopped immediately and
problems be corrected before operation is resumed.
6.2 General LED Error Codes and Resolutions
1. Transmitter LED flashes RED quickly (every 0.2 seconds)
when any button is pressed: One of the pushbuttons is jammed.
2. Transmitter LED flashes RED slowly (every 0.5 seconds): The transmitter memory is defective.
3. Transmitter LED is steady RED when any button is pressed: The transmitter batteries are low.
4. Receiver Error LED flashes slowly (every 0.5 seconds): The receiver memory is defective.
Note: The receiver error LED is located on the inside of the receiver. Observe the
appropriate precautions when opening the unit.
IF A PROBLEM IS FOUND, PLEASE CONTACT THE DISTRIBUTOR FOR REPAIR.
6.3 Change of Fuses
Depress the fuse cover and turn counter-clockwise with a flat screwdriver to open up the fuse cover. Remove
the old fuse and insert a new fuse into the cover. Place fuse cover along with the fuse into the fuse holder
base. Depress the fuse cover and turn clockwise with flat screwdriver.
DC Type Relay
Board Reference:
Relay board
shown left is for
701P0080-DC
AC Type Relay
Board Reference:
Relay board
shown left is for
701P0080
95-00-0-036 Rev D 10 Control Chief Corporation