User Manual

TRAIN CHIEF® II LRCS W/ Lightweight OCU-BT – OPERATORS MANUAL

95-00-0-062, Rev 08 1-3 Control Chief Corporation

1.7 Safety

The safety guidelines in this manual are not intended to replace any rules or regulations or any

applicable local, state, or federal governing laws. The following information is to be used in

conjunction with all other rules and/or regulations already in existence. It is important to read all

safety information before operating any wireless radio remote control system. The Federal

Railroad Administration (FRA) has published a Notice of Safety Advisory 2001-1 (in the Federal

guidelines for the operation of remote control locomotives. A copy of all referenced FRA

regulations can be obtained directly from the FRA or contact Control Chief for help in obtaining a

copy of these regulations.

The term “Remotely Controlled Locomotives” or “Remote Control Locomotives” (RCL) refers to a

locomotive, which, through use of a wireless radio operator control unit and receiver system, can

be operated by a person not physically located at the controls within the confines of the locomotive

cab. The wireless Remote Control Operator (RCO) must exercise extreme caution and be alert at

all times.

Only properly trained persons (certified and qualified in accordance with 49 CFR Part 240, as

conventional operation of a locomotive under the same circumstances would require) should be

operating RCLs. RCLs should not be operated by any person who cannot read or understand

signs, notices and operating instructions that pertain to the locomotive operation.

Any person operating a remote controlled locomotive should possess the following knowledge

and/or skills:

 Current certification on methods of safe train handling, operating rules, conditions of

equipment, personal safety practices

 Knowledge/training on hazards specific to locomotive operation

 Knowledge/training of safety rules for RCLs

 Knowledge of the radio transmitter/receiver equipment/system

 Knowledge/training on all required inspections and testing

 Knowledge on transferring control from one operator to another

 Reporting unsafe or unusual operating conditions

Upon going off duty, each RCO should place the RCL in manual operation and properly secure it

and the OCU to prevent unauthorized operation. The recommended practice for OCU security

includes the designation of a dedicated, lockable location for OCU storage, which can have access

controlled to only appropriately trained / knowledgeable personnel.

When operating a RCL, the RCO should NOT:

 Ride on a freight car under any circumstances

 Mount or dismount moving equipment

 Operate any other type of machinery

 Stand or walk within the gage of the track or foul the track on which the movement is occurring

RCOs should ensure that the track is clear and properly aligned ahead of the remotely controlled

movement. Therefore, RCL operations should be operated at restricted speed not to exceed a

speed that will enable stopping the movement within half the range of vision assuring that all

movements are protected.