User Manual

TRAIN CHIEF® II LRCS W/ Lightweight OCU-BT – OPERATORS MANUAL
95-00-0-062, Rev 09 4-7 Control Chief Corporation
CAN CEL MEN UXMTR > >
* F1
LOCO
* F2 * F3 * F4
XMTR READY - F4 TO EXI T
XMTR ADDRESS 2 4 2 4
STATUS OK
ASSI GN XMTR TO LOCO PUSH < F1 >
< F4 >
configuration to be assigned. (The HMI display will provide a message to identify
the nature of the error; “Invalid OCU Config” for example.)
• The assignment process is complete
when the OCU sounds a one (1) second
beep and the HMI “Status” field displays
“OK”. The OCU and controller are ready
for Remote Control operation.
• Push F4 to Exit screen
• Upon successful assignment the OCU will
beep the audible alarm once, the display
will show Locomotive Running number,
operating frequency, battery status, and
the OCU A or B indicator on the keypad
will illuminate to show the OCU assigned
designator.
• To assign another OCU (B if system permits) or a new OCU A, return to the main menu
(F4 key) and repeat the steps for the new OCU
Note
: for OCU Mode “A&B” the RCU will not allow RCL operations until both OCU’s have
been registered and have established their communication links.
OCU Setup and Assignment Completed.