User Manual

TRAIN CHIEF® II LRCS W/ Lightweight OCU-BT – OPERATORS MANUAL

95-00-0-062, Rev 09 4-4 Control Chief Corporation

BRAKE & M AI N RES. PRESSURES

TROUBLESH OOTI N G

STORED ERRORS 1 - 5

STORED ERRORS 6 - 1 0

F1 F2 F3

ALI GN ARROW &

PRESS ENTER

XMTR TO LOCO ASSI GM EN T

XMTR

"A"

* F1

PUSH < F1 > TO SELECT

LOCO ASSI GN M EN T.

COMMAND/ STATUS

SCREEN FOR XMTR TO

XMTR > > > LOCO

F2 F3 * F4

MEN U

< F4 >

4.2.3 OCU Assignment Procedure – Locomotive Setup (Train Chief® II)

• Access the “OCU >> LOCO ASSIGNMENT”

selection from the HMI screen select menu by

using the F1/F2 for UP/DOWN scroll.

• Select the “OCU >> LOCO ASSIGNMENT”

screen using the ENTER button.

• The “OCU >> LOCO ASSIGNMENT” screen

allows for the selection of the appropriate OCU

to be assigned. In most cases this will be the

“A” OCU only. When a system is equipped

with the Selective Dual Control feature, “A”

and “B” selections would be available to

support assignments for dual OCU’s.

• Select the appropriate OCU by pushing the

associated function button (F1 or F2) for the

desired OCU configuration. This will bring up

the “COMMAND/STATUS” screen.

The locomotive is now ready to register an OCU(s) for RCL operations. Continue to the next step.

Note

: for OCU Mode “A&B” the RCU will not allow RCL operations until both OCU’s have

been registered and have established their communication links.

OCU MODE >> LOCO SETUP

OCU ASSIGNMENT

OCU >> LOCO ASSMT

OCU