User Manual

TRAIN CHIEF® II LRCS W/ Lightweight OCU-BT – OPERATORS MANUAL
95-00-0-062, Rev 08 3-4 Control Chief Corporation
3.2.3 OCU Operation Controls and Associated Functions
Figure 3-3: Lightweight OCU-BT Controls
Power Button:
Push-On / Push-Off switch to apply power to the OCU. Power is supplied from the
battery pack and the power bridge. Depending on the charge state of the power
bridge, the OCU may activate for a short time without an installed battery. However,
operations are not recommended without a battery.
Transfer (Pitch) button:
The TRANSFER button is used to transfer movement control of the locomotive from
one OCU to another. Refer to section 4.6 in this manual describing the Selective Dual
Control feature.
Tilt Time Extend (F1):
This button extends the allowable tilt time to 60 seconds. To activate this command
the operator must depress the F1 button for 2 seconds until the OCU beeps to
acknowledge the command.
Status (F4):
Depressing the F4 key causes the OCU to initiate a status report from the locomotive
or activate a status menu that will be shown on the OCU display. Refer to the OCU
display section for more details.
Transfer
(Pitch)
Power
Tilt Time Extend (F1) Status (F4)