User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 98 of 199
Vacation—Lets you set the Heat Set Point and Cool Set Point when the homeowner is on
vacation. Use the up or down arrows to set the heat and cool set points, and then click OK.
Use Remote Temperature Sensor—Sets the Thermostat to use either the on-board Local
temperature sensor (default) or an optional Remote temperature sensor to control the HVAC
system by selecting the Use Remote Temperature Sensor radio button.
Buttons— Locks local buttons to prevent unwanted changes to Thermostat settings. Select the
Locked and Unlocked radio buttons. Note: If buttons are disabled, they will be re-enabled
when the Thermostat power cycles. This is a safety mechanism to prevent a Thermostat from
becoming completely inoperable if it were removed from a project while the buttons were
disabled.
Advanced Properties
General Setup
Backlight Mode—Lets you select your preferences for the backlight. Select On Button
Press to light the backlight for ten (10) seconds when any button is pressed. Select