User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 94 of 199
“Setting Up a Wireless Thermostat”
“Programming the Control4 Thermostat Schedule”
“Using the Wireless Thermostat Advanced Properties”
2.5.10.1 Setting Up a Wireless Thermostat
Use the Control4
®
Composer Pro System Design and Connections views to set up a Control4
Wireless Thermostat.
Prerequisites
1. Ensure that your project has a Control4 Controller added to the project tree and is identified on
the Control4 system.
2. Ensure that the Thermostat is installed at the wall as directed in the Control4 Wireless Thermostat
Installation Guide available on the Control4 Dealer website.
3. Ensure that the Control4 Wireless Thermostat is added to the project tree.
To configure a Wireless Thermostat for the Control4 system:
1. Start Composer and connect to a Director.
2. Click System Design.
3. Verify that the Wireless Thermostat is in the project tree.
4. To identify the device, click Connections.
5. Click the Network tab.
6. Make the network connection. To do this, select the Control4 Wireless Thermostat object in the
IP Network Connections pane, and click Identify.
7. In Identify mode, go to the physical Control4 Thermostat, and press the center button four (4)
times. This identifies the Thermostat's network address to the Controller, and identifies the device
to the Control4 system. The device’s address appears in the following dialog and in the IP
Network Connections pane.