User guide

Composer Pro User Guide

Saved: 1/20/2012 1:31:00 PM

200-00005 Composer Pro

User Guide Part 1

Page 92 of 199

Radio Buttons:

• Toggle Type. Select if the device needs two (2) wires always touching to stay on.

• Pulse Type. Select if two (2) wires only need to touch momentarily to turn the device on

or off.

Pulse length is x milliseconds. Add the value here.

4. To use this option, select the Pulse Type radio button, and select the Pulse Length is x

milliseconds for the relay pulse (the default is 500 milliseconds).

2.5.9.4 Configure Single Contact Relay Support

Use the Control4

Composer Pro System Design view to check and change Single Contact Trigger

support for contacts.

When using a contact in your project, the physical change of the contact’s state might not always

result in a single open-to-close or close-to-open state change, but rather bounce between states

multiple times before the final state is reached.

To eliminate false notification of the contact state to the Control4 system, you can configure a

'Debounce Timer' to allow the system to see only a single state change.

In the System Design view, you can set this option in the Properties pane when you select a contact.

To set this option:

1. Start Composer and connect to a Director.

2. Click System Design.

3. Select the contact object from the project tree. View its properties in the Properties pane.