User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 85 of 199
2.5.8.4 Configuring a 7” Portable Touch Screen with Camera (C4-TSMC7)
Use the Control4® Composer Pro System Design and Connections views to add and configure this
device.
Prerequisites
1. Ensure that the 7" Portable Touch Screen with Camera (C4-TSMC7-EN) is installed as directed in
the Control4 7" Portable Touch Screen with Camera Setup Guide available on the Control4
Dealer website. Note: If you want to install the new 7" Portable Touch Screen with Camera,
ensure that the part number says "C4-TSMC7-EN" when you add the driver.
2. Ensure that your project has a Control4 Controller added and identified in the Control4 system.
To add and configure a 7" Portable Touch Screen with Camera:
1. Start Composer and connect to a Director.
2. Click System Design.
3. In the project tree, select the room where the Touch Screen resides. In the Items pane > My
Drivers tab > User Interface > double-click Touch Screen - 7" Portable to add the object to the
project tree.
4. Click Connections.
5. In the Connections view, click the Network tab to make the necessary network connection.
Note: If this Touch Screen will be providing audio output, the Touch Screen needs to be identified
as an Audio end point for the room.
6. Select the Portable 7” Touch Screen V2 object, and click the Identify button.
7. In Identify mode notice the Touch Screen button highlighted in the Composer Pro pane. Go to the
physical 7" Portable Touch Screen with Camera, and press the button indicated in Composer Pro
to identify the Touch Screen to the Control4 system.
8. When the address appears on the Composer Pro screen, click Close.
9. (Optional) To configure the properties, click System Design.
10. In the project tree, select the Portable 7” Touch Screen V2 object.
11. View and change the properties in the Properties pane.
Modifiable properties include:
Backlight Level—Use the up or down arrows to set the light level of the backlight. You can
change the brightness of the backlight with this option by percentage, so 100% is On at full
brightness and 0% is Off. Click Set to save.
Backlight Preset Level—Lets you set the default backlight level. If you ever restart or power the
Touch Screen again, this is the backlight level it would go to. Click Set to save.
WiFi Signal Strength—If using WiFi, shows you the strength of your wireless signal.
Enable Camera—Check to use the camera with this device for video intercom.
2.5.8.5 Configure a 7” Tabletop Touch Screen
Use the Control4® Composer Pro System Design and Connections views to add and configure this
device.