User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 81 of 199
• Gateway—Displays the MAC address of the ZigBee server (usually your Controller
unless you specify otherwise).
• MAC—Displays the System Remote Control's own MAC address.
• Firmware Version—Displays the current firmware version of the System Remote
Control.
• Watch/Listen Button Behavior—If you select one of the options below, the following action
occurs when you press the Watch button.
• No Action—If you select this option and you press the Watch button, nothing happens.
This option can be tied to programming a button (see the section below).
• Select Most Recently Used Device—Lists the last three (3) devices; e.g., DVD player,
Media Player, Television, etc.
• Show Device List—Lists the source device of the selection.
12. (Conditional) Change ZigBee Channel: If you need to change the ZigBee channel to match the
Controller’s channel or to improve reception, do the following at the System Remote Control SR-
250.
If the System Remote Control is NOT identified, follow these steps:
a. Press buttons 2, 4, 8, 6, #, *, and then press the List button (in that order) to get into Edit
mode.
b. Use the up or down arrows to pick the ZigBee channel.
c. Press Select to change the ZigBee channel.
d. Press CNCL to exit Edit mode.
If the System Remote Control IS identified, follow these steps:
a. Press the List button once or twice to display the menu options.
b. Press buttons 2, 4, 8, 6, #, * and then press the List button (in that order) to get into Edit
mode.
c. Use the up or down arrows to pick a ZigBee channel.
d. Press Select to change the ZigBee channel.
e. Press CNCL to exit Edit mode.
2.5.8.2.1 Program the SR-250 Programmable Buttons
On the System Remote Control SR-250, you can program six (6) buttons (Red, Green, Yellow, Blue,
*, and #) to perform programmed activities. You can program these buttons to execute any of the AV
device’s macros or IR codes or they can be programmed by room.
To program the SR-250 programmable buttons:
1. Start Composer and connect to a Director.
2. Click System Design.
3. Ensure that you have the following devices in your project:
• Controller
• System Remote Control SR-250
• An AV device to be controlled