User guide

Composer Pro User Guide

Saved: 1/20/2012 1:31:00 PM

200-00005 Composer Pro

User Guide Part 1

Page 41 of 199

See the following sections as applicable to configure the tuner:

“Activate the XM Satellite Radio Service”

“Configure the Multi Tuner”

“Set Up Radio Stations”

Prerequisites

Ensure that the Multi Tuner, Version 1 or 2, is installed as directed in the Control4 Multi Tuner

Installation Guide.

2.5.6.6.1.1 Activate the XM

Satellite Radio Service

Notes:

• Version 1: Model # AVM-TUN1X-B or tuners upgraded with the XM Module Kit require a

monthly subscription to the XM Satellite Radio service to receive XM radio channels.

• Version 2: Model # C4-TUN2-E-B_with_C4-XMOD or tuners upgraded with the XM Module

Kit require a monthly subscription to the XM Satellite Radio service to receive XM radio

channels.

To subscribe and activate these services:

1. Use the Select dial to tune the XM tuner to channel 0 and record the XM Radio ID (SDARS ID)

that displays in the LCD window.

2. Contact XM Satellite Radio Inc., to subscribe to the XM radio service. Go to

http://www.xmradio.com or call XM’s Listener Care at 1-800-XMRADIO (800-967-2346), which

requires your SDARS ID.

3. When instructed to do so by XM Satellite Radio Inc., tune the XM tuner to Channel 1 for about 20

minutes. When the tuner begins receiving XM stations, the LCD screen is enriched with station-

specific information.

4. If the XM tuner is not receiving XM stations after 20 minutes:

a. Move your antenna to a new location.

b. Go to

http://www.xmradio.com/refresh/.

c. Tune to Channel 1 again, and wait approximately 20 minutes for the LCD screen to refresh.

2.5.6.6.1.2 Configure the Multi Tuner

Notes: (1.) If you are installing C4-TUN2-E-B or C4-TUN2-E-B_with_C4-XMOD, refer to the Version 2

notes. (2.) If you are installing models AVM-TUN1-B or AVM-TUN1X-B, refer to Version 1 notes.

To add and configure the Multi Tuner V1 to an existing system:

1. Start Composer and connect to a Local or Remote Director.

2. Click System Design.

3. In the System Design view, select the room in the tree where the Multi Tuner will reside.

4. In the My Drivers tab, go to Audio/Video > Tuner and double-click Tuner.

5. In the list displayed, double-click the applicable Control4 Multi Tuner model:

• Version 1: Multi Tuner for the AVM-TUN1-B model.