User guide

Composer Pro User Guide

Saved: 1/20/2012 1:31:00 PM

200-00005 Composer Pro

User Guide Part 1

Page 27 of 199

2.5.5.5 Configure Multiple Controllers

Use the Control4

Composer Pro System Design view and Connections > Network tab to configure

multiple Controller. If you have more than one (1) Controller in your Control4 system, you must

designate one of them as the Primary Controller. The others will be Secondary Controllers.

To add and configure multiple Controllers:

1. Start Composer and connect to a Director on Local Network.

2. From the Directors dialog that appears, choose the Director’s network address of the Primary

Controller hardware you are setting up, and click Connect.

3. If you have multiple Controllers in the system, then when you make this selection, you are

defining the Primary Controller to the system. The next time you launch Composer Pro, only the

network address of the Director of the Primary Controller appears on this screen. If the correct

address is not listed, click Add to add the address manually.

4. Click System Design.

5. In the System Design view, add the room where Controller resides.

6. While selecting a room, click the My Drivers tab under the Controller, and double-click Controller

to add it to the system. Do the same for all the Controllers you plan to add to the system.