User guide

Composer Pro User Guide

Saved: 1/20/2012 1:31:00 PM

200-00005 Composer Pro

User Guide Part 1

Page 19 of 199

• Top LED Link—If checked, swap the On and Off state and color on the top LED.

• Bottom LED Link—If checked, swap the On and Off state and color on the bottom LED.

• Buttons Attached—If checked, pressing the buttons on the Dimmer or Switch directly

controls the connected load.

• LED Attached—If checked, the LED state is controlled by the button presses. If

unchecked, the LED state and colors can be controlled by custom programming.

• Hold Ramp Rate Up—The rate in seconds at which the load is increased when the top

button is held down.

• Hold Ramp Rate Down—The rate in seconds at which the load is decreased when the

bottom button is held down.

• Network—The current channel, gateway, MAC address and firmware version of the selected

Dimmer or Switch. These boxes cannot be edited.

2.4.2.1.3 Wireless Keypad Properties

When selecting a Wireless 2, 3 or 6 Button Keypad in System Design, the Properties pane appears.

This pane allows custom configuration of the Keypad.

To configure a 3-Way Switch, see “Configuring Lights for 3-Way.”

Keypad Properties:

• LED—(button displayed when each button is selected in the Properties pane):

• Keypad Managed—If checked, the LED state is controlled by pressing the buttons on the

Keypad.

o Push Color—Indicates the LED color when the button is pushed.

o Release Color—Indicates the LED color when a pressed button is released. If

unchecked, the LED state can be controlled by custom programming.

o On Color—The button LED color when its state is On.

o Off Color—The button LED color when its state is Off.