User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 182 of 199
2.11.1.3 Release 1.7.3
• Updated firmware for the 4-Zone Amplifier, with the following changes:
• Better fan speed control (less fan “noise”)
• Input gain control from front panel
• Power save enable/disable from front panel
• Balance control from front panel
• Shorted output detect
2.11.1.4 Release 1.7.2
• Polling. Removal of “polling” functionality from Director: With the introduction of Control4’s
1.6 system software, functionality was added to the system for polling dimmers to determine
their current light level. Now, with the 1.7.2 release, Control4 has removed polling
functionality from Director. Each time the Dimmer light level changes, the system is
automatically notified. This improves graphical navigator tracking of light levels and linked
keypad LED tracking.
• Drivers. A new security driver for the GE Networx NX8-587E virtual keypad interface (added
to the Online Database for drivers).
• Commands. Added a device-specific programming command to the Control4 Dock for iPod
driver which allows the LED on the dock to be turned on/off using programming. Please note
that the LED will automatically turn on when the Identify button is pressed.
• Dimmers. In conjunction with the support for the new Control4 Wireless ELV Dimmer, on all
Control4 Dimmers you now have the ability to configure a load profile. While the load profile
settings are primarily intended for the Wireless ELV Dimmer, they also work on the standard
Dimmer. Specifically, you can use Minimum On Level (%) for Dimmers that have a dimmable
fluorescent (or CFL) load. This changes the dimming range so that the 0-100% seen by the
user starts at the Minimum On Level %.
• Touch Screens. Resolved problem where the 7” Touch Screen buttons would stop working if
the Touch Screen was rebooted or lost, and regained its network connection while the
system was still running.
• Zones.
• Resolved problem where phantom audio zones would remain displayed on the Zones
page of a Touch Screen if a network message wasn’t received.
• Resolved a problem with the zone feedback from an HAI OmniPro security panel
incorrectly displaying off by 1.
• Thermostat. Resolved a problem whereby using Composer HE or Composer Pro’s device
control for a Control4 Thermostat would set the mode to Off.
• Screen Saver. Enabled photo Screen Saver for Home Controller HC-200, HC-300, and HC-
500 operating in PAL display mode.
• IP Cameras. Resolved problem which prevented IP Cameras from being hidden or re-
ordered using Composer Pro.
2.11.1.5 Release 1.7.1
• Support for the Control4 Dock for iPod hardware release.
• Support for the 7" Wall-Mount Touch Screen.
• Support for ISO file scanning using the Video Media interface on network file storage devices.