User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 159 of 199
2.9.2.4 Example: Define the Control and Audio/Video Connections
This section discusses using Control4® Composer Pro views to define AV connections.
Note: This process follows “Verifying the Network Connections.”
Control/AV connections are visible when you select the Control/AV tab in the Connections view. The
Control/AV tab lets you define the physical connections between the Controller or other devices,
including AV signals, IRs, relays, contacts, and/or serial connections.
Tip: If connections do not appear as needed, edit the driver to create the needed connections. See
“Editing a Driver Using the Driver Wizard.”
The following steps are described in the next sections:
“Verify that all Control and AV Connections use Room Properties”
“Disconnect/Remove Control/AV Connections”
“Re-assign Control/AV Connections”
“Update Connections in the project if you change locations”
2.9.2.4.1 Verify that all Control and AV Connections Use Room Properties
To verify all Control and AV connections by checking room properties:
1. Click the System Design view.
2. Select a room.
3. On the default tab Audio Video Devices, see if your AV devices are accessible in the room. If an
AV device is not there, see “Make and Verify Connections.”