User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 149 of 199
2.9.2.2 Example: Make and Verify the Connections
This section discusses using Control4® Composer Pro views to make and verify the connections.
Note: This process follows Example: Design and Create the Project.
In the Connections view, you can:
• Identify Control4 devices to establish a Network connection
• Check all Network connections
• Define AV connections
• Define Control connections
Note: When only one appropriate connection is available in a room for a given connection type,
Composer Pro assumes the connection (example: if a TV is the only Audio Output device in a room,
the system assumes that the Audio Output connection is routed to the TV). This feature adds value to
Composer Pro, but increases the need to verify every connection.
Note: To remove a connection, right-click on the connection and choose Disconnect.
To make connections:
1. In Composer Pro, click the Connections view.
2. Identify the Control4 devices that connect to the Controller through the network. Go to each
physical device and press the button indicated on the Composer Pro screen.
a. Click the Network tab > IP Network.
Notice the devices that do not have an address listed under the Address column.